New Sub Driver SDX15

Discussion in 'DIY' started by E Jones, May 12, 2007.

  1. E Jones

    E Jones Active Member

    Joined:
    May 10, 2007
    Messages:
    1,560
    Likes Received:
    1
    I was just checking out CSS and noticed this on their front page:
    http://creativesound.ca/

    SDX 15"

    This is the first high excursion Subduction driver using a 3" XBL2TM motor with dual 2 ohm voice coils.

    - fiberglass/nomex woven cone with foam surround

    - high power, low inductance design, 4 layer 3" copper voice coil and copper shorting ring inside the magnet

    - forged and machined T-yoke and top plate with larger radiused pole vent for low aerodynamic noise

    - high excursion spider with integrated lead wire

    - attractive cast aluminum basket design with cast aluminum trim ring

    - long Xmax and a "bottomless" basket design

    Specs say 30mm xmax... not bad for $270

    -EJ
     

Share This Page